Want to build your own cabinet like an expert? Here are simple tips to follow for your DIY project. However, since you’ll need power tools for this, make sure to check out Drill Tools Center for the best power drill to help you get things done. Now here are the steps:
- Establish the layout by marking up the walls.
Draw a level line of 19 1/2 inches from the top of the base cabinet and the bottom of the upper cabinet. Label the location where the cabinets and appliances are to be situated. Mark the edge of the first cabinet to be installed with a vertical line.
- Remove all the contents of the cabinet including the shelves, doors, and drawers to make it lighter.
Use a painter’s tape to mark the location of the doors. Mark at the top hinges to indicate where the starting point is. Remember, most upper cabinets have no top or bottom because they are designed to be hung in any direction; thus, mark the hinges where you deem proper.
- Put a thin wedge before hanging cabinets in the wall.
Failing to do so may result in accidental pulling of the cabinet’s back when it is fastened into place. Position a level across the wall then slide a shim snugly at the bottom. Use a pin or a piece of tape to secure it into place.
- Install the upper cabinets first.
Use a ledger board as a support for the upper cabinets to ensure a straight alignment. The ledger facilitates in holding the cabinets safely in place when screwing them onto the wall.
- Apply the scribing trick.
Scribing is one of the key techniques in cabinet installation. To scribe, get the measurement of the farthest distance between the cabinet exterior and the wall. Mark on the filler strip and clamp onto the cabinet flush. Use a block of wood to trace the pencil line down the filler strip. Stick on a piece of masking tape to highlight the pencil line and to protect the finish from the adjacent saw table.
- Mark the stud locations on the inside of the upper cabinets.
Measure the distance from the wall to the center of the stud. If installing a 1/2 inch-thick cabinet, subtract 7/8 inch and measure over that distance starting from the cabinet interior. Mark the top and bottom nailing strip. Take note that the cabinet exteriors do not appear flushed with the entire cabinet because the 7/8 inch serves as the thickness of the cabinet wall and the distance of how much the walls are recessed.
- Install using good screws.
There’s no sense in using low-quality screws when you are on a DIY cabinet installation worth thousands of dollars. Avoid the drywall screw type because when they snap, you’ll end up with another set of an extra hole.
- Fasten the back securely.
Align the base cabinets along the line on the wall. Once the correct alignment is obtained, use shims to make sure the sides are level. Measure and align correctly because you don’t want your precious china sliding down a slanted shelf.
- Secure cabinets to the floor.
Use 2x2s to secure islands and peninsulas to the floor. Trace the outline before screwing them at 1/2 inch on the inside of the line to make sure the screws are embedded in the thickness of the cabinets. If necessary, position flooring blocks under the 2x2s.
After completing the job, step back to marvel at your finished work.